2010 ADA Standards for Accessible Design Pocket Guide
206.2.1 Site Arrival Points.
At least one accessible route shall be provided within the site from accessible parking spaces and accessible passenger loading zones; public streets and sidewalks; and public transportation stops to the accessible building or facility entrance they serve.
EXCEPTIONS: 1. Where exceptions for alterations to qualified historic buildings or facilities are permitted by 202.5, no more than one accessible route from a site arrival point to an accessible entrance shall be required.
2. An accessible route shall not be required between site arrival points and the building or facility entrance if the only means of access between them is a vehicular way not providing pedestrian access.
Advisory 206.2.1 Site Arrival Points. Each site arrival point must be connected by an accessible route to the accessible building entrance or entrances served. Where two or more similar site arrival points, such as bus stops, serve the same accessible entrance or entrances, both bus stops must be on accessible routes. In addition, the accessible routes must serve all of the accessible entrances on the site.
Advisory 206.2.1 Site Arrival Points Exception 2. Access from site arrival points may include vehicular ways. Where a vehicular way, or a portion of a vehicular way, is provided for pedestrian travel, such as within a shopping center or shopping mall parking lot, this exception does not apply.
35.151(i) New Construction and Alterations; Curb Ramps.
(1) Newly constructed or altered streets, roads, and highways must contain curb ramps or other sloped areas at any intersection having curbs or other barriers to entry from a street level pedestrian walkway.
(2) Newly constructed or altered street level pedestrian walkways must contain curb ramps or other sloped areas at intersections to streets, roads, or highways.
ETA Editor’s Note:
Requirements for curb ramps, sidewalks and other elements in the public right of way may be covered by other Federal, State or local standards and regulations. The U.S. Department of Transportation and most State departments of transportation are revising their design standards and regulations for the public right of way based on recent research and guidelines being developed by the U.S. Access Board and the Federal Highway Administration. It is the responsibility of the design professional to comply with these public right of way requirements.
User Comments/Questions
Add Comment/Question