Hello. Please sign in!

2012 Texas Accessibility Standards (TAS) Pocket Guide

Note: This document or portion of document references a state or local code that aligns with the 2010 ADA Standards requirements.

802.1 Wheelchair Spaces.

Wheelchair spaces shall comply with 802.1.

802.1.1 Floor or Ground Surface.

The floor or ground surface of wheelchair spaces shall comply with 302. Changes in level are not permitted.

EXCEPTION: Slopes not steeper than 1:48 shall be permitted.

802.1.2 Width.

A single wheelchair space shall be 36 inches (915 mm) wide minimum where two adjacent wheelchair spaces are provided, each wheelchair space shall be 33 inches (840 mm) wide minimum.

Figure (a) is a plan view of a single wheelchair space 36 inches (915 mm) wide minimum.

(a)
single space

 Figure (b) is a plan view of two wheelchair spaces side by side. Each space is 33 inches (840 mm) wide minimum.

(b)
two spaces

Figure 802.1.2 Width of Wheelchair Spaces in Assembly Areas

802.1.3 Depth.

Where a wheelchair space can be entered from the front or rear, the wheelchair space shall be 48 inches (1220 mm) deep minimum. Where a wheelchair space can be entered only from the side, the wheelchair space shall be 60 inches (1525 mm) deep minimum.

Figure (a) shows a wheelchair space that can be entered from the front or rear that is 48 inches (1220 mm) deep minimum.

(a)
front or rear entry

Figure (b) shows a wheelchair space entered from the side that is 60 inches (1525 mm) deep minimum.

(b)
side entry

Figure 802.1.3 Depth of Wheelchair Spaces in Assembly Areas

802.1.4 Approach.

Wheelchair spaces shall adjoin accessible routes. Accessible routes shall not overlap wheelchair spaces.

Advisory 802.1.4 Approach. Because accessible routes serving wheelchair spaces are not permitted to overlap the clear floor space at wheelchair spaces, access to any wheelchair space cannot be through another wheelchair space.

802.1.5 Overlap.

Wheelchair spaces shall not overlap circulation paths.

Advisory 802.1.5 Overlap. The term "circulation paths" used in Section 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy. Where the circulation path provided is wider than the required aisle width, the wheelchair space may intrude into that portion of the circulation path that is provided in excess of the required aisle width.

[MORE INFO...]

*You must sign in to view [MORE INFO...]