Hello. Please sign in!

Solutions

Documents

Resources

2013 California Standards for Accessible Design Pocket Guide

Note: This document or portion of document references a state or local code that aligns with the 2010 ADA Standards requirements.

11B-1009.4.5 Grab bars.

At least one grab bar complying with Section 11B-609 shall be provided on the transfer wall. Grab bars shall be perpendicular to the pool wall and shall extend the full depth of the transfer wall. The top of the gripping surface shall be 4 inches (102 mm) minimum and 6 inches (152 mm) maximum above transfer walls. Where one grab bar is provided, clearance shall be 24 inches (610 mm) minimum on both sides of the grab bar. Where two grab bars are provided, clearance between grab bars shall be 24 inches (610 mm) minimum.

Exception:  Grab bars on transfer walls shall not be required to comply with Section 11B-609.4.

Grab bars at transfer walls are shown perpendicular to the pool wall and extending the full depth of the transfer wall. Figure (a) shows in plan view two grab bars with a clearance between them of 24 inches minimum. Figure (b) shows in plan view one grab bar with a clearance of 24 inches minimum on both sides. Figure (c) shows in side elevation a height of the grab bar gripping surface 4 to 6 inches above the wall, measured to the top of the gripping surface.

FIGURE 11B-1009.4.5

GRAB BARS FOR TRANSFER WALLS

Source: 2013 California Standards for Accessible Design Pocket Guide by California Building Standards Commission (edited by Evan Terry Associates) - published 01/01/2015

Previous Next

Related Keywords

Related Section Numbers

User Comments/Questions

Add Comment/Question

[MORE INFO...]

*You must sign in to view [MORE INFO...]