11B-1002.4.4 Clearances

Note: This document or portion of document references a state or local code that aligns with the 2010 ADA Standards requirements.

11B-1002.4.4 Clearances.

Clearances for wheelchair spaces shall comply with Section 11B-1002.4.4.

Exceptions:

1. Where provided, securement devices shall be permitted to overlap required clearances.

2. Wheelchair spaces shall be permitted to be mechanically or manually repositioned.

3. Wheelchair spaces shall not be required to comply with Section 11B-307.4 _|Vertical Clearance|_.

[2010 ADAS] Advisory 1002.4.4 Clearances Exception 3. This exception for protruding objects applies to the ride devices, not to circulation areas or accessible routes in the queue lines or the load and unload areas.

11B-1002.4.4.1 Width and length.

Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface.

11B-1002.4.4.2 Side entry.

Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to enter and exit the ride.

[2010 ADAS] Advisory 1002.4.4.2 Side Entry. The amount of clear space needed within the ride, and the size and position of the opening are interrelated. A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride. Additional space for maneuvering and a wider door will be needed where a side opening is centered on the ride. For example, where a 42 inch (1065 mm) opening is provided, a minimum clear space of 60 inches (1525 mm) in length and 36 inches (915mm) in depth is needed to ensure adequate space for maneuvering.

11B-1002.4.4.3 Permitted protrusions in wheelchair spaces.

Objects are permitted to protrude a distance of 6 inches (152 mm) maximum along the front of the wheelchair space, where located 9 inches (229 mm) minimum and 27 inches (686 mm) maximum above the floor or ground surface of the wheelchair space. Objects are permitted to protrude a distance of 25 inches (635 mm) maximum along the front of the wheelchair space, where located more than 27 inches (686 mm) above the floor or ground surface of the wheelchair space.

An elevation drawing of a person seated in a wheelchair on an amusement ride shows that objects may protrude 6 inches maximum along the front of the wheelchair space where located 9 inches minimum and 27 inches maximum above the floor or ground surface of the wheelchair space. Objects may protrude a distance of 25 inches maximum along the front of the wheelchair space, where located more than 27 inches above the floor or ground surface.

FIGURE 11B-1002.4.4.3
PROTRUSIONS IN WHEELCHAIR SPACES IN AMUSEMENT RIDES

[MORE INFO...]

*You must sign in to view [MORE INFO...]

Solutions

Documents

Resources

2016 California Standards for Accessible Design Pocket Guide - Eff. Jan. 1, 2017