Dimensional Tolerances in Construction and for Surface Accessibility

1.1.6 Accessible surfaces should be as smooth as possible. This includes localized variations in slope as well as bumpiness created by small, individual units such as bricks, concrete pavers, or wood slats.

In most cases using concrete or asphalt minimizes the potential problems with bumpiness. However, smaller paving units may be used if the gap between the units and the lippage (difference in offset between units) is minimized. As a guide, research conducted at the University of Pittsburgh on concrete pavers found that limits on whole body vibration as established in ISO 2631, Evaluation of Human Exposure to Whole - Body Vibration were not exceeded if the bevel on the units was less than or equal to 6 mm (1/4 in.) and the pavers were placed in a 90 - degree herringbone pattern.

Local variation in slope can also be a problem for users of wheelchairs and other mobility aids. For example, although a ramp may meet the overall slope requirements of 1:12, a dip or hump along the ramp may create a stumbling hazard or a short incline greater than 1:12. Specifications should include limits on how many local variations will be accepted and the methods by which accessible surfaces will be measured.

For accessible surfaces constructed of small, individual units, such as concrete pavers or wood slats, the drawings (along with the specifications) should include the best method to install the material to minimize variations in smoothness and maintain a uniform surface over the life span of the material.