Questions and Answers: Transportation Services for Individuals with Disabilities

2. Question: What is the minimum width needed for a level boarding railroad passenger station platform to meet the accessibility requirements of the Americans with Disabilities Act (ADA)?

Answer:

Under 49 CFR Part 37, all new or altered railroad station platforms, including non-level boarding platforms, used for intercity rail passenger service or commuter rail passenger service must be readily accessible to and usable by persons with disabilities, including persons who use mobility aids like wheelchairs or walkers. 49 CFR 37.9, 37.41-37.43, 37.55. We have received questions from entities constructing or altering platforms as to the minimum platform width needed to accommodate passengers using such mobility aid devices. This Q&A may be used as guidance for the minimum width needed for level boarding platforms.

A level boarding intercity or commuter railroad passenger station platform can have a gap between the passenger car door threshold and the edge of the platform that is at the maximum horizontal dimension of 10 inches on tangent track and 13 inches on curves and a maximum vertical dimension of 5.5 inches. 49 CFR 37.42(f). At level boarding platforms, where the gap exceeds plus or minus 5/8 inch vertical or 3 inches horizontal (49 CFR 37.42(f)), a bridge plate is typically used to allow a passenger using a wheelchair or other mobility device to move from the platform to the passenger car. While they can vary in dimensions, a typical bridge plate is approximately 3 feet long. Per ADAAG 304.3, a space of at least 5 feet is required on the platform for a passenger using a wheelchair to make a turn to enter the bridge plate and onto the passenger car.

For a conventional level boarding side passenger platform with a railing or a wall on the platform side opposite the track, the minimum platform width should be the sum of the maximum dimensions listed above – i.e., 8 feet.

For an end loading island passenger platform (where passengers are entering or exiting the platforms of a stub-end station) located between two tracks, our calculation needs to account for the width of tactile strips. The additional width of the tactile strips (2 feet) required by 49 CFR 37.9(a) (applying ADAAG 705.2 and 810.5.2) for the next track should be added to the above dimension, which yields a total minimum width of 10 feet for an end loading level boarding island platform.

For a level boarding island passenger platform with vertical pedestrian access (by elevator, stairs, escalators, etc.), the minimum width should be the width of the vertical access facility (typically in the range of 8-12 feet) plus twice the 6 feet required by 49 CFR 37.42(e)(1) for clearances around the sides of the stairwell, yielding 20-24 feet. The level boarding island with vertical pedestrian access platform may be tapered to 10 feet at the end(s) of the platform, as long as the gap between the car and the platform through the curved portion complies with 49 CFR 37.42(f), which defines the maximum allowable gap at level boarding platforms to be 10 inches on tangent and 13 inches on curved tracks.

Circumstances may arise where a 15-inch high passenger platform designed to provide level boarding to typical bi-level passenger cars is also used by conventional single level passenger cars, which typically have 51-inch car door heights. In this case, the 3 feet allocated for a bridge plate should be replaced by either the 5 feet used by an on-board lift or 4 feet used by a platform mounted lift. Thus, a 15-inch high platform used by single level passenger cars should be treated as if it were a non-level boarding platform.

Table 1. Summary of Minimum Platform Width Guidance

Note: A 15-inch platform used with 51-inch equipment is treated as “other than level boarding.” 

The General Counsel of the Department of Transportation has reviewed this document and approved it as consistent with the language and intent of 49 CFR Parts 27, 37, and 38.