2013 California Standards for Accessible Design Pocket Guide

11B-405.9 Edge protection.

Edge protection complying with Section 11B-405.9.2 shall be provided on each side of ramp runs and at each side of ramp landings.

[2010 ADAS] 405.9 Edge Protection.  Edge protection complying with 405.9.1 or 405.9.2 shall be provided on each side of ramp runs and at each side of ramp landings.

Exceptions:

1.      Edge protection shall not be required on ramps that are not required to have handrails and have sides complying with Section 11B-406.2.2.

2.      Edge protection shall not be required on the sides of ramp landings serving an adjoining ramp run or stairway.

3.      Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area specified in Section 11B-405.7.

11B-405.9.1 Reserved.

[2010 ADAS] 405.9.1 Extended Floor or Ground Surface.  The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505.

11B-405.9.2 Curb or barrier.

A curb, 2 inches (51 mm) high minimum, or barrier shall be provided that prevents the passage of a 4 inch (102 mm) diameter sphere, where any portion of the sphere is within 4 inches (102 mm)  of the finish floor or ground surface.  To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp.

FIGURE 11B-405.9.2 ‡‡

CURB OR BARRIER EDGE PROTECTION