Allegion LCN 1000 Surface Mounted Door Control

Applications

• For aluminum, hollow metal, or wood swinging doors and frames

• Can be used with hinge or pivot mounted door

• Mounts on a 1 3/4' transom without adapter plates

• Adapter plates and other installation accessories availabvle for unusual conditions

• 1000 series closers mount three ways. Closers with regular or hold-ope arm mount hinge side or top jamb. Parallel arm, designated with a "P", closers include - 62PA SHOE required for parallel arm mount. 1460T mounts hinge side, top jamb (pull side) and stop face.

• Non-handed for right and left swinging doors

• Closers to meet ADA reduced opeing for requirements

• Adjustable hydraulic backcheck cushions opeing swing prior to 90 degrees

• Separate regulation of general closing speed and latching speed

• Joints in arm and shoe adapt to uneven trim

• Reversible shoe to boost latching power on double lever arms

Materials

• High strength cast iron cylinder

• Forged steel main arm for all EDA, Cush, 1460HD and 1460T Arms

• One piece forged steel piston

• Heat treated pinion

• All weather fluid eliminates seasonal adjustments

• High efficiency, full complement, low friction bearings

• Tamper resistant regulating screws

• Full rack and pinion hydraulic action

• Quiet, low friction track and roller combination for all single lever arm closers

Fasteners
1260, 1460, 1460T series closers are shipped with: A stardard SELF-REAMING and TAPPING SCREW (SRT) pack that contains Philips heat SRT screws to install the closer. Standard LCN thru bolts (TB) can be installed on 1 3/4" (44mm) thick doors with 1/4-20 machine screws. Optional thru bolt (TB) sizes are available for 1 5/8" (41mm) or 1 3/8" (35mm) door thickness, but this must be specified when ordering.

Note 1: for Through Bolts, specify door thickness if other than 1 3/4" (44mm).

Note 2: Phillips head, metric machine screws are available, please specify.

Note 3: LCN recommends the use of wood screws in wood door applications.