Norton Surface Mounted 5900 Series Low Energy Door Operator

The 5900 Series is a full-featured, extremely quiet, low energy door operator designed for moderate to high traffic doors. This cost-effective operator is available for either push- or pull-side mounting and is ideal for any application designed to meet the Americans with Disabilities Act (A.D.A). “One touch” programming combined with the operators' built-in ability to calibrate door mass, offers Norton customers a smart, dependable solution.

Features:

• Ease of installation and setup
    - Simple instructions
    - "One touch" programming
• Application versatility and ease of adjustment
    - Non-handed units
    - Push- or pull-side mounting
    - Interfaces with electric hardware
    - Integrates with access control system
• Operation startup options
    - Wall switches
    - Motion sensor
    - Radio frequency device
    - Push and Go
• Presence Detector input
• Sync cable for double doors; synchronizes closing of two operators
   

Functions:

• Power Assist - when unit is activated, it allows the door to be opened manually with a force less than 5 lbs.
• Push and Go (selectable) - as the door is manually opened, the operator “senses” movement and opens door to the full-open position.
• Obstruction Detection
    – Open - door closes if it hits an obstruction while opening
    – Close (Stop on Stall) - door will stop once it hits an obstruction and rest against the obstruction until obstruction is removed
• Motor Startup Delay - delays operator opening
• Infinite Hold Open - door will hold open at set position until power is turned off
• Power Latch (selectable) - increases latch power
• Selector mode switch (3 position)
    – Off - disables signal inputs
    – On - activates signal inputs
    – Hold Open - activates the unit to the hold open position
   

Electrical Data:

• Power input 120 VAC, 60 Hz (+10%, -15%)
• Current draw .75A
• 12VDC @ .5A output, 24VDC @ .25A output, 24VDC @ .4A output